DKG-114-J Datakom Sterownik Agregatu Prądotwórczego

 
DKG-114-J 

DKG-114-J to sterownik agregatu prądotwórczego zaprojektowany do zdalnego lub manualnego rozruchu / zatrzymania pracy silnika. Protokół J1939 CANBUS.

FEATURES:

Both manual and remote starting and stopping
ECU control and monitoring via J1939 CANBUS
Zero power consumption at rest
Various engine brands and models supported
Automatic shutdown on fault condition
Built in alarms and warnings LED displays
Survives cranking dropouts
Sealed front panel
Plug-in connection system for easy replacement
Low cost
Small dimensions
Standard panel dimensions, (72x72mm)

INPUTS AND OUTPUTS: 

FUEL: Fuel solenoid control.(10 A @28V-DC)
START: Engine starter solenoid control. (10 A @28V-DC)
ALARM: Positive output relay activated by any alarm condition. (10 A @28V-DC)
DC SUPPLY: 12 or 24 volts DC, (+) and (-) terminals.
REMOTE START: If the battery positive voltage is applied to this input the genset will start. If the positive voltage is removed, it will stop.
CHARGE: This terminal will be connected to the charge alternator D+ terminal. It will supply the
excitation current.
J1939-H / J1939-L: CANBUS connection terminals. The 120 ohms termination resistor is
inside the unit. It may be removed by jumper control.

TECHNICAL SPECIFICATIONS:

DC Supply Range: 9.0 to 30.0 V-DC
Cranking dropouts: survives 0 V for 100ms.
Typical Standby Current: 0 mA-DC in OFF mode.
Maximum Operating Current: 250 mA-DC (Relay outputs open)
DC Relay Outputs: 10 A / 28V
Charge excitation current: 150mA-min
Number of starts: 3
Start duration: 8 sec.
Wait between starts: 10 sec.
Alarm duration: 1 minute.
Protection delay: 8 sec.
Operating temp.: -20°C (-4°F) to 70 °C (158°F).
Storage temp.: -40°C (-40°F) to 80 °C (176°F).
Dimensions: 72 x 72 x 43 mm (WxHxD)
Humidity: max 95% (non-condensing)
Panel Cut-out Dimensions: 69 x 69 mm minimum.
Weight: 180 g (approx.)
Case Material: High Temp. ABS (UL94-V0, 100°C)
IP Protection: front panel:IP65, rear: IP30
Conformity: (EU directives)
-2006/95/EC (low voltage)
-2004/108/EC (electro-magnetic compatibility)
Norms of reference:
EN 61010 (safety requirements)
EN 61326 (EMC requirements)