DKG-114 Datakom Sterownik Agregatu Prądotwórczego

 
DKG-114

DKG-114 to sterownik agregatu prądotwórczego zaprojektowany do zdalnego lub manualnego rozruchu / zatrzymania pracy silnika.

FEATURES:

Both manual and remote starting and stopping
ECU control and monitoring via J1939 CANBUS
Zero power consumption at rest
Various engine brands and models supported
Automatic shutdown on fault condition
Built in alarms and warnings LED displays
Survives cranking dropouts
Sealed front panel
Plug-in connection system for easy replacement
Low cost
Small dimensions
Standard panel dimensions, (72x72mm)

INPUTS AND OUTPUTS: 

FUEL: Fuel solenoid control.(10 A @28V-DC)
START: Engine starter solenoid control. (10 A @28V-DC)
AUXILIARY: Positive output relay activated by any alarm condition (or optionally stop solenoid or preheat output). (10 A @28V-DC)
LOW OIL PRESSURE SWITCH: negative closing switch input for low oil pressure protection.
HIGH TEMP SWITCH: negative closing switch input for engine high temperature protection.
DC SUPPLY: 12 or 24 volts DC, (+) and (-) terminals.
REMOTE START/SPARE FAULT: If the battery positive voltage is applied to this input the genset will start. If the positive voltage is removed, it will stop. A battery negative connection will generate a SPARE ALARM.
CHARGE: This terminal will be connected to the charge alternator D+
terminal. It will supply the excitation current and monitor the charge alternator status.
G: Generator phase voltage.
NEUTRAL: Generator neutral terminal.

TECHNICAL SPECIFICATIONS:

Alternator voltage: 277V-AC (Ph-N)
Alternator frequency:0-200Hz.DC
Supply Range:
9 to 33 V-DC.
4 to 33 V-DC while cranking
Current consumption:
0 ma-DC in OFF mode  
250 mA - DC max. (Relay outputs open)

Total DC Current Output Rating: 10A-DC
Max. Current for each Terminal: 10A-RMS
Operating temp:-30C (-22F) to 70C (158F)
Storage temp: -40C (-40F) to 80C (176F)
Maximum humidity: 95% non-condensing.
IP Protection: IP65 from front panel, IP30 from the rear
Dimensions: 72 x 72 x 43mm (WxHxD)
Mounting: Front panel mounted with rear retaining steel spring.
Panel cut-out dimensions: 68 x 68mm.
Weight: 180 g (approx.)
Charge excitation current: 36mA @ 12V-DC
Cranking dropouts: survives 0V for 100ms.
Genset low frequency limit: 30Hz.
Genset high frequency limit: 57Hz.
Frequency error delay: 3 sec.
Preheat timer: 10 or 30 sec selectable.
Number of starts: 3
Start duration: 6 sec.
Wait between starts: 10 sec.
Cooldown duration: 2 min.
Stop duration: 30 sec.
Alarm duration: 1 minute.
Protection delay: 10 sec.
Case Material:
Flame Retardant High                                  
Temperature ABS (UL94-V0, 110C)
Conformity (EU directives)
-73/23/EEC and 93/68/EEC
-89/336/EEC, 92/31/EEC and 93/68/EEC
Norms of reference:
EN 61010    (safety requirements)
EN 50081-2 (EMC requirements)
EN 50082-2 (EMC requirements)